SO BAD they stopped selling it - Qidi Tech X-Plus 3 Review - QIDITECH

4K views Jan 1, 2024
publisher-humix

fauxhammer.com

Verified Humix Creator Badge

Buy the QIDI Tech X-PLUS 3 Here: https://shareasale.com/r.cfm?b=2395089&u=3060349&m=130069&urllink=&afftrack= UPDATE 19th April 2023 - at 04:20 I mention "tightening knobs at the corners of the bed" - I meant to say - "adjust the z-offset for the corners of the bed" There are no manual knobs to tighten. I missed this slip in my edit - as did QIDI who checked the content (for factual errors only) before release. This is a weird one for me. As many of you know, this is a miniatures channel, so I print various miniatures and models. I was amazed by the advertised spec of this machine in regard to print speed. After all, I'm printing at the lowest possible layer heights (often 0.05mm or below) on these printers to avoid as much post-processing (layer lines) as I can. So, my biggest issue is printing speed! I'm usually just patient, but when I get a document that says "600mm/s print speed" I get excited!!! Did the printer live up to these expectations? You'll find out in the first 100 seconds of this video. I must stress that QIDI has recently provided a huge firmware update available here: https://qidi3d.com/pages/software-firmware This Printer was provided by ZBANX This Video is part of our series looking for the Best 3D printer for Miniatures; https://www.fauxhammer.com/top-10/the-best-3d-printer-for-miniatures-models/ Special thanks to the following Creator who provided models Joel & Ellie Busts - Sid Naique - https://www.sidnaique.com/portraits Artis Opus FauxHammer Essentials Set: https://store.artis-opus.com/products/fauxhammer-mixed-brush-set-5-brush-deluxe FauxHammer Patreon - https://www.patreon.com/fauxhammerblog FauxHammer Facebook Group - https://www.facebook.com/groups/PaintHub

#Other